64
Using external equipment
AVC System (rear view)
VCR
SCART cable (commercially available)
Watching a VCR image
Connecting a VCR
You can use the INPUT 2 terminal when connecting a VCR and other audiovisual equipment.
If your VCR supports TV-VCR advanced “AV Link” systems (see page 65), you can connect the VCR to the
INPUT 2 terminal on the AVC System using the fully-wired SCART cable.
AV Link advanced system
• Download tuning information directly from TV to VCR (Preset download).
• While watching TV, you can record a programme with a one-touch press of the VCR recording button. (WYSIWYR*)
* Refer to your VCR operation manual as some VCRs have an exclusive key for WYSIWYR. See page 65 for details on
“WYSIWYR”.
• When you press the play button on the VCR, the TV automatically turns on from standby and displays a VCR image.
• When you press the system standby button on the VCR, the TV also enters standby mode.
NOTE
• TV-VCR advanced “AV Link” systems may not compatible with some external sources.
• It is recommended to connect to the INPUT 2 terminal when using a decoder for ground wave signal input with a VCR. If
INPUT 2 signals preset in auto installation or programme setup, make sure to set “Decoder” to “INPUT2” in the Programme
Setup “Manual” menu. (See page 32.)
Displaying a VCR image
To watch a VCR image, select “INPUT2” from the
“INPUT SOURCE” menu using b on the remote
control unit or INPUT on the Display.
The setting is stored and can be selected in the “INPUT
SOURCE” menu.
NOTE
• Each time b is pressed, the input source toggles.
• If the VCR image does not come in clearly, you may need
to change the input signal type setting on the “Input Select”
menu.
• Refer to your VCR operation manual for the signal type.
• See page 73 for how to select the signal type.
Decoder
SCART cable
(commercially available)
MENU
[
Option
...
Input Select
]
CVBSY/C
INPUT SOURCE
TV
DTV
INPUT1
INPUT2
INPUT3
INPUT4
PC
(For INPUT2 signal)
LC-30AD1E(E)-g 03.10.31, 1:25 PM64
To Next Page
Loading...
Need help?
General
