Sharp MX-M905

7-2
MANUAL FINISHING►MANUAL FINISHING
MANUAL FINISHING
In manual finishing mode, you can set for finish on copied or printed pages.
You can select the manual finishing mode if the inserter is installed. When the finisher (100-sheet stapling), saddle stitch
finisher (100-sheet stapling), punch module, or folding unit is installed, finishing operations, such as stapling, punching
or folding can be performed.
MANUAL FINISHING
Manual finishing cannot be used if the use of manual finishing or inserter is prohibited in "Settings".
To specify whether or not to prohibit the use of manual finishing or inserter:
In "Settings (administrator)", select [System Settings] → [Common Settings] → [Enable/Disable Settings] → [Disable Manual
Finishing] to set the use of manual finishing. Select [System Settings] → [Common Settings] → [Enable/Disable Settings] →
[Disabling of Inserter] to set the use of the inserter.
A
A
A
A
A
B
A
A
B
A
C
A
C
D
A
A
B
D