Sharp MX-M905 - Page 754

8-19
SYSTEM SETTINGS►SETTING MODE LIST
* When an internet fax expansion kit is installed
Fax Data Receive/Forward (Manual)
*1 When a facsimile expansion kit is installed
*2 When an internet fax expansion kit is installed
Inbound Routing (Forwarding/Storing) Settings
•Add New – No Yes
X Server Settings No Yes
 Receive Settings No Yes
• Internet Fax Receive Enabled No Yes
• POP3 Server – No Yes
• Port Number 110 No Yes
• POP Authentication Disabled No Yes
• User Name – No Yes
•Password – No Yes
- Change Password Disabled No Yes
• POP3 Communication Timeout 60sec. No Yes
• Reception Check Interval Setting 5 minutes No Yes
• Enable SSL Disable No Yes
 Default Settings No Yes
• I-Fax Own Name and Address Set No Yes
- Set I-Fax Own Name – No Yes
-Own Address – No Yes
• Direct SMTP Setting No Yes
- Port Number (Receive) 25 No Yes
- Timeout 300 seconds No Yes
- Port Number (Send) 25 No Yes
- Timeout 300 seconds No Yes
Setup Items Factory default setting U A
● Fax Data Receive/Forward (Manual) (page 8-110)
X Fax Settings*
1
No Yes
 Receive Settings Auto Reception No Yes
X Internet Fax Settings*
2
No Yes
 Manual Reception Key in Initial Screen Enabled No Yes
Setup Items Factory default setting U A
● Inbound Routing (Forwarding/Storing) Settings (page 8-111)*
X Inbound Routing Settings No Yes
 Table Registration No Yes
• Table Name – No Yes
 Sender Settings for Received Data No Yes
Setup Items Factory default setting U A