Sheeran LOOPER X - FX

24
(5.5) FX
(5.5.1) Applying FX
On the FX Page, you can assign multiple effects (called FX Racks) at once to an audio input or looper
track. Each FX Rack is made up of multiple effects that can be individually edited and toggled on the
(5.5.2) Menu > FX > Editing FX page.
To enter the FX page, tap the Navigation Menu icon at the top-left of the touchscreen, and then tap
the FX icon. You can also access this by using the Function footswitch.
To add an FX Rack, tap the plus sign (+) in an empty slot.
To enable or bypass an FX Rack, tap the Track 1–4 pedals, or tap the On/Off button on the touchscreen.
To change settings for the FX Rack, tap the Edit icon on the touchscreen. See the following (5.5.2) Menu
> FX > Editing FX chapter for more information.
To remove an FX Rack, tap the Remove icon on the touchscreen. If you want to change the FX rack type
for a track, you must remove it first, and then add a new FX rack.
To change how the FX are applied, tap the Pre and Post icons on the touchscreen. When Pre is selected,
the effects are applied to the incoming audio signal before it is recorded. When Post is selected, the effects
are applied to the recorded audio signal, allowing you to make changes to the effect parameters after the
audio has been recorded.
To customize the pedal assignments of the FX Racks, tap the (5.5.3) Menu > FX > Pedal Assign button
at the bottom of the touchscreen.
To assign FX parameters to an external expression pedal, tap the (5.5.4) Menu > FX > Expression Pedal
Assign button at the bottom of the touchscreen.
To exit the FX Page, press the Function pedal, or tap the Navigation Menu icon in the top-left corner of
the touchscreen.
Edit FX Rack
Enable/Bypass
FX Rack
Remove
FX Rack
Add
FX Rack
Select FX
Routing Order