38
(5.10.2) Audio
Phantom Power (+48V): This setting determines whether phantom power (+48V) is enabled (On) or
disabled (Off) for all four Inputs.
Important: Only enable phantom power if your microphone requires it. Most dynamic microphones
and ribbon microphones do not require phantom power, while most condenser microphones do.
Consult your microphone's documentation to find out whether it needs phantom power.
XLR Ground Lift: This setting determines whether the XLR ground lift feature is enabled (On) or
disabled (Off). Use this feature to reduce hum or noise in the signal from the XLR Outputs.
1/4 Output Level: This setting determines the output level of the 1/4" Outputs. When set to Line, the
output level will be +18 dBu. Use this setting if you are connecting Sheeran Looper X to a full-range,
flat-response amplifier, PA speaker, mixer, or audio interface. When set to Amp, the output level will
be +6 dBu. Use this setting if you are connecting the Sheeran Looper X to a traditional guitar amplifier.
Tuner Output: This setting determines the audio routing of inputs that are using the built-in tuner.
Select None to keep the tuner audio muted from all outputs. Select Phones, XLR, or 1/4” to send the
tuner audio to these specific outputs, or select All to send the tuner audio to all of the above outputs.
To Next Page
Loading...
