4
(1.0) Introduction
Welcome to your Sheeran Looper X!
This is a comprehensive guide designed for you to get the most out of Looper X. We recommend you read
through this guide before playing.
(1.1) Box Contents
Sheeran Looper X
USB Cable
Power Adapter (2 pieces)
Quickstart Guide
Safety & Warranty Manual
(1.2) Support
For the latest information about this product (documentation, technical specifications, system
requirements, compatibility information, etc.) and product registration, visit sheeranloopers.com.
For additional product support, visit sheeranloopers.com/support.
(2.0) Setting Up Your Rig
1. Position Sheeran Looper X on a flat surface, and away from any liquid hazards.
2. Make sure your output device is switched off.
IMPORTANT! In the (5.10) Global Settings menu, make sure you set the Outputs to send signal at amp
level if you are using a traditional guitar amplifier, or line level (default) if you are using a full-range
flat-response amplifier, mixer, PA speaker or audio interface.
3. Connect input devices like a guitar and microphone to the Inputs on the rear panel, and connect your
output device to the Outputs.
4. Connect the barrel end of 19 V, 3.42 A, center-positive power adapter to the Power Adapter Input on
the rear panel, and then connect the IEC plug to a power outlet.
5. Power on Sheeran Looper X.
6. Power on your output device.
When shutting Sheeran Looper X down, power off your output device first, then power off Sheeran Looper
X.
To Next Page
Loading...
