39
(5.10.3) USB Audio
Enable: This setting determines whether or not Sheeran Looper X is sending a USB audio signal over
a USB connection. Set to On to enable sending of the USB audio signal with the selected Sample Rate.
Set to Off to disable the USB audio signal. (To change the Sample Rate, set USB Audio to Off first,
select the correct sample rate, set USB Audio to On again, and restart your DAW.)
Sample Rate: This setting determines the sample rate of the USB audio signal: 44.1 kHz, 48.0 kHz, 88.2
kHz, or 96.0 kHz. Remember to select the same sample rate as the one in your DAW. Also, set it before
opening your DAW.
Input Level: This setting determines the incoming level of the USB audio signal coming from your
computer.
Mode: This setting determines what audio signal how the Sheeran Looper X sends its audio signal over
the USB connection and how its outputs function while doing so:
• Live: The audio signal will be sent to your computer as well as to the Sheeran Looper X’s outputs.
• DAW: The audio signal will be sent to your computer only. The Sheeran Looper X’s outputs will
be disabled to prevent any latency while monitoring.
To Next Page
Loading...
