7
5. RECORD + PLAY Pedal
Press this pedal to record, overdub, and start playback of your loop.
• First Press: Start recording the loop (pedal indicator LED turns red).
• Second Press: Sets the loop length and begins overdubbing (pedal indicator LED turns orange).
• Third Press: Stops overdubbing and begins playback (pedal indicator LED turns green).
You can also adjust this order using the Pedal Logic setting in the (5.10.1) Menu > General Settings >
General page.
Press and hold this pedal to undo the last layer recorded.
Note: The first layer of a track cannot be undone.
6. STOP Pedal
Press this pedal at any time to stop tracks or sections, depending on the current looper mode selected:
• Multi Mode: Stops all tracks.
• Sync Mode: Stops all tracks.
• Song Mode: Stops an individual section.
• Band Mode: Stops a section or the primary track.
• Free Mode: Stops all tracks.
See (4.2) Operation > Looper Modes to learn more about each mode.
Press and hold this pedal to clear all tracks.
7. MODE Pedal
Press this pedal to enter Mute Mode. While in Mute Mode, use the Track 1–4 (A–D) pedals to mute each
track or section.
Press and hold this pedal to change the looper mode or access additional pages. See (5.9.6) Menu >
Loop Settings > Customize Pedal Menu for more information on how to customize the Mode pedal
and menu.
8. FUNCTION Pedal
Press this pedal to access the following functions:
Tuner Peel
FX Clear All
Load Clear Track
Save Exit
Press and hold this pedal to access additional loop editing functions:
Bounce Transpose
Multiply Fade
Speed Reverse
Backing Track Exit
See (4.4) Operation > Functions to learn more about each function.
Quickly double-press this pedal to enable tap tempo. While enabled, press the RECORD + PLAY pedal
in time with the desired tempo. When you are finished, press the FUNCTION pedal again to exit.
To Next Page
Loading...
