49
ENGLISH
49
ATTENTION
The hand should be in a relaxed
position and able to apply pressure
on the lever.
Position of the clutch lever
Changing the headlight bulb
In order to be able to pull on the lever properly during
the clutch release operation, it is essential that the
position of the lever is adapted to the physique of
the rider.
To alter the position:
- Loosen the 2 screws on the lever-switch
assembly.
- Sit on the seat.
- Place your feet on the footrests.
- Place your hand on the lever and position it as
desired.
- Secure the position by tightening the two
screws .
After changing the position, check and adjust the
clutch cable.
This operation should be performed with the ignition
off.
Removal:
- Remove the central screw located in the top
centre.
- Remove the two headlight plate rubbers .
- Tilt it forwards.
WARNING
ATTENTION
A
A
B
A
A
A
B
To Next Page
Loading...
Need help?
General
