67
ENGLISH
67
Draining engine oil
This operation must be carried out with the engine
switched off but still warm.
It is advisable to perform this operation while the
engine is warm, and therefore care should be taken
to avoid any possible burns.
To drain the oil from the engine:
- Remove the exhaust pipe .
- Remove the bottom crankcase protector ,
using the 2 front screws and the 2 screws, 2 nuts
and 2 washers at the rear.
- Place a container under the engine.
- Remove the ller plug - dipstick to aid draining.
- Remove the drain plug bolt .
- Wait a few minutes until all the oil has drained out.
- Ret the drain plug bolt .
- Rell with fresh oil.
- Ret the ller plug-dipstick .
- Ret the bottom crankcase protector .
- Ret the exhaust pipe .
Type of oil: SAE 10-40
Quantity of oil: 1.900 cc
Check the level while proceeding with the oil lling,
to make sure the maximum level is not exceeded.
CHANGING THE ENGINE OIL FILTER requires
technical knowledge and should therefore be done
by an Ofcial Sherco Service Centre.
WARNING
TIP
WARNING
ATTENTION
A
B
C
D
B
B
A
A
D
C
C
C
To Next Page
Loading...
Need help?
General
