6666
Checking and topping up the engine oil
The oil level is checked using the dipstick attached
to the ller plug located on the right-hand side of the
crankcase.
The ller plug dipstick incorporates MIN and MAX
marks for checking the oil level.
This operation must be carried out with the engine
switched off but still warm.
To inspect it correctly, make sure the motorcycle is
in an upright position.
To check the level:
- Unscrew the threaded plug .
- Clean the dipstick .
- Screw the plug in fully.
- Remove the plug once again.
- Check the oil level on the marks on the dipstick .
Topping up with oil:
- Top up with oil if necessary.
- Ret the oil plug .
Type of oil: SAE 10-40
The engine oil level must be between the MIN and
MAX marks .
If the machine is ridden on dirt roads, the time
scheduled on the maintenance table for changing
the lter must be reduced.
The air lter should be lightly smeared with oil.
WARNING
WARNING
WARNING
Maintenance processes
B
B
A
A
A
A
A
B
B
B
To Next Page
Loading...
Need help?
General
