55
ENGLISH
55
Checking and topping up the rear brake fluid
Bleeding the rear brake fluid
The rear brake uid reservoir is located next to the
kick-start lever.
To inspect the uid correctly, make sure the
motorcycle is in an upright position.
To top up the uid:
- Remove the threaded cap from the reservoir .
- Remove the internal rubber and the pressure ring.
- Top up the uid.
Type of brake uid: DOT4.
The brake uid level must be between the MIN and
MAX marks .
To bleed the rear brake system:
- Remove the reservoir cap (see previous section).
- Remove the black protective cap .
- Press the rear brake pedal and hold it down.
- Slightly loosen the protected device with the
black bleed nipple positioned next to the hose
attachment.
- Repeat various times until the air has been
eliminated from the uid circuit.
- Ret the black protective cap .
- Ret the reservoir rubber and cap.
Place a cloth under the bleed nipple to absorb the
uid.
Brake uid is highly corrosive, therefore remove any spillage that may have come into contact with
parts of the motorbike.
WARNING
WARNING
WARNING
TIP
A
B
B
AC
A
B
A
B
C
A
To Next Page
Loading...
Need help?
General
