5454
Maintenance processes
Checking and topping up the front brake fluid
Bleeding the front brake fluid
The front brake reservoir is located next to the
brake lever. It is tted with an inspection window for
checking the uid level.
To inspect it correctly, make sure the motorcycle is
in an upright position.
To top up the uid:
- Remove the two screws from the reservoir
cover.
- Remove the internal rubber.
- Top up the uid.
Type of brake uid: DOT4.
The brake uid level must be between 3 and 4 mm
from the top edge.
To bleed the front brake system:
- Remove the reservoir cover (see previous section).
- Remove the black protective cap .
- Press in the front brake lever and hold it in.
- Slightly loosen the protected device with the
black bleeding nipple positioned next to the hose
attachment.
- Repeat various times until the air has been
eliminated from the circuit.
- Ret the black protective cap .
- Ret the reservoir rubber and cover.
Place a cloth under the bleed nipple to absorb the
uid.
Brake uid is highly corrosive, therefore remove any spillage that may have come into contact with
parts of the motorbike.
WARNING
WARNING
WARNING
TIP
B
C
A
A
A
A
A
B
C
To Next Page
Loading...
Need help?
General
