3-2
IRAffinity-1
Chapter 3 Installation
After unpacking, confirm that all parts are included in accordance with the standard accessory list.
WARNING
To ensure safe operation, contact your Shimadzu representative for installation, adjustment, or re-installation
after moving the instrument to a different site.
NOTE
If the cold IRAffinity-1 is brought into a warm room, leave the IRAffinity-1 for approximately 2 hours to
prevent dew condensation in the interferometer, then unpack the interferometer (especially in winter).
NOTE
1. The personal computer and the printer are not included in standard accessories. Separately prepare
them. We can offer the preinstall package in which the interface and the software are already installed.
Omit section 3.4 to use the preinstall package.
2. The IRAffinity-1 is equipped with the minimum required instruction manual in the printed form under
consideration of the global environment. The detailed description of commands required to operate the
IRAffinity-1 is given in the electronic document (Help) attached to the software. Refer to it.
3.1 Inspecting Standard Accessories
To Next Page
Loading...
Need help?
General
