3-6
IRAffinity-1
Chapter 3 Installation
When your computer controls the IRAffinity-1, an instrument driver program must be installed. When the PC is
used for data manipulation and/or printing, and not for FTIR control, installation of instrument driver is not
needed.
3.4.1 Installation of the Driver Program for the IRAffinity-1
A driver program for the IRAffinity-1 should be installed to control it.
1. Wire the IRAffinity-1 and your PC by referring to the section 3.3 of the Instruction Manual -
User's System Guide.
2. Turn them ON, and then Windows will automatically recognize the IRAffinity-1 with Plug & Play
function. In this case, Windows should be run as Administrator.
3. Windows requests the installation of the driver program. When Windows asks where to find
the driver, check [CD-ROM drive] in the Driver setup wizard dialog box.
4. Insert the IRsolution installation CD-ROM into your CD-ROM drive. When the Installation
program of IRsolution starts, cancel it by clicking the [Cancel] button.
5. Follow the message on the screen. Windows automatically install the necessary drivers.
6. Install IRsolution software in next step.
3.4 Installing the Software
To Next Page
Loading...
Need help?
General
