5-14
IRAffinity-1
Chapter 5 Maintenance and Inspection
5.6.3 Status Monitor
The status monitor show the condition of the FTIR and information of installed accessory. The
status window shows following items.
Fig. 5.10 Status Monitor
Laser Indicates whether the He-Ne laser is operating.
Green The He-Ne laser is operating normally.
Red The He-Ne laser is not operating.
Please contact your SHIMADZU representative.
Lamp Indicates whether the Infrared light source is operating.
Green The light source is operating normally.
Red The light source is not operating.
Please contact your SHIMADZU representative.
Humidity Indicates the humidity level in the interferometer.
Green The humidity in the interferometer is low enough.
Red The humidity in the interferometer is high. The dry unit might
break down.
1. Disconnect the power cord immediately and do not use your
IRAffinity-1.
2. Remove the Top cover and replace silica gel packages.
3. Please contact your SHIMADZU representative.
SW Indicates presence and setting of the Beam switching kit.
None The beam switching kit is not installed.
Green The beam switching kit is installed and working normally.
Internal; IR beam is introduced to the sample compartment and
the standard detector can be used.
External; IR beam is introduced to the outside and the optional
detector such as Microscope can be used.
Validate; A polystyrene film is inserted in the beam. This mode is
for automatic validation.
Red The beam switching kit is installed but not working.
Please contact your SHIMADZU representative.
To Next Page
Loading...
Need help?
General
