MXA910 Response:
< REP METER_RATE 00000 >
Get Audio Peak Level
Command String:
< GET x AUDIO_IN_PEAK_LVL >
Where nnn is the audio level and is 000-060.
MXA910 Response:
< REP x AUDIO_IN_PEAK_LVL nnn >
Get Audio RMS Level
Command String:
< GET x AUDIO_IN_RMS_LVL >
Where nnn is the audio level and is 000-060.
MXA910 Response:
< REP x AUDIO_IN_RMS_LVL nnn >
Get Preset
Command String:
< GET PRESET >
Where nn is the preset number 01-10.
MXA910 Response:
< REP PRESET nn >
Set Preset
Where nn is the preset number 1-10. (Leading zero
is optional when using the SET command).
Command String:
< SET PRESET nn >
Where nn is the preset number 01-10.
MXA910 Response:
< REP PRESET nn >
Get Preset Name
Send one of these strings to the MXA910.
Command String:
< GET PRESET1 >
< GET PRESET2 >
< GET PRESET3 >
etc
Whereyyyyyyyyyyyyyyyyyyyyyyyyy is 25 characters
of the preset name.The MXA910 always responds
with a 25 character preset name
MXA910 Response:
< REP PRESET1 {yyyyyyyyyyyyyyyyyyyyyyyyy} >
< REP PRESET2 {yyyyyyyyyyyyyyyyyyyyyyyyy} >
< REP PRESET3 {yyyyyyyyyyyyyyyyyyyyyyyyy} >
etc
Get Gate Out Status
Where x is ASCII channel number: 0 through 8. It
is not necessary to continually send this command.
The MXA910 will send a REPORT message
whenever the status changes.
Command String:
< GET x AUTOMIX_GATE_OUT_EXT_SIG >
The MXA910 will respond with one of these strings.
MXA910 Response:
< REP x AUTOMIX_GATE_OUT_EXT_SIG ON >
< REP x AUTOMIX_GATE_OUT_EXT_SIG OFF >
Get LED State
Command String:
< GET DEV_LED_IN_STATE >
The MXA910 will respond with one of these strings.
MXA910 Response:
< REP DEV_LED_IN_STATE OFF >
< REP DEV_LED_IN_STATE ON >
Set LED State
Shure IncorporatedMXA910 Ceiling Array Microphone
45/572017/10/18
To Next Page
Loading...
