Send one of these commands to the MXA910.
Command String:
< SET DEV_LED_IN_STATE OFF >
< SET DEV_LED_IN_STATE ON >
The MXA910 will respond with one of these strings.
MXA910 Response:
< REP DEV_LED_IN_STATE OFF >
< REP DEV_LED_IN_STATE ON >
Get LED Brightness
Command String:
< GET LED_BRIGHTNESS >
Where n can take on the following values:
0 = LED disabled
1 = LED dim
2 = LED default
MXA910 Response:
< REP LED_BRIGHTNESS n >
Set LED Brightness
Where n can take on the following values:
0 = LED disabled
1 = LED dim
2 = LED default
Command String:
< SET LED_BRIGHTNESS n >
MXA910 Response:
< REP LED_BRIGHTNESS n >
Get LED Mute Color
Command String:
< GET LED_COLOR_MUTED >
Where nnnn can be RED, GREEN, BLUE, PINK,
PURPLE, YELLOW, ORANGE, or WHITE
MXA910 Response:
< REP LED_COLOR_MUTED nnnn >
Set LED Mute Color
Where nnnn can be RED, GREEN, BLUE, PINK,
PURPLE, YELLOW, ORANGE, or WHITE
Command String:
< SET LED_COLOR_MUTED nnnn >
MXA910 Response:
< REP LED_COLOR_MUTED nnnn >
Get LED Unmute Color
Command String:
< GET LED_COLOR_UNMUTED >
Where nnnn can be RED, GREEN, BLUE, PINK,
PURPLE, YELLOW, ORANGE, or WHITE
MXA910 Response:
< REP LED_COLOR_UNMUTED nnnn >
Set LED Unmute Color
Where nnnn can be RED, GREEN, BLUE, PINK,
PURPLE, YELLOW, ORANGE, or WHITE
Command String:
< SET LED_COLOR_UNMUTED nnnn >
MXA910 Response:
< REP LED_COLOR_UNMUTED nnnn >
Get LED Mute Flashing
Command String:
< GET LED_STATE_MUTED >
Where nnn can be ON, OFF, or FLASHING
MXA910 Response:
< REP LED_STATE_MUTED nnn >
Set LED Mute Flashing
Where nnn can be ON, OFF, or FLASHING
Command String:
< SET LED_STATE_MUTED nnn >
Shure IncorporatedMXA910 Ceiling Array Microphone
2017/10/1846/57
To Next Page
Loading...
