Scanning frequency
You can set the scan frequency in the range from 400 Hz to 1,000 Hz (Device tree >
Parameters > Read configuration).
Object trigger control
Device with an additionally connected read cycle sensor (for example a photoelectric
sensor at the “Sensor 1” digital input): select the “Sensor 1” setting (Device tree >
Parameters > Object trigger control).
Test the configured settings during operational use of the system. Modify the settings if
necessary.
COMMISSIONING 7
8017840/19OF/2021-10-28 | SICK O P E R A T I N G I N S T R U C T I O N S | CLV61x
51
Subject to change without notice
To Next Page
Loading...
