EasyManua.ls Logo

SICK deTec4 Ex II 3GD - Page 129

SICK deTec4 Ex II 3GD
156 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Minimum Typical Maximum
Input voltage HIGH (active) 13 V 24 V 30 V
Input current HIGH 2 mA 5 mA 7 mA
Input voltage LOW (deactivated) –3 V 0 V 3 V
Input current LOW –0.1 mA 0 mA 0.5 mA
Control switch actuation time 50 ms
Permissible cable resistance
1)
Supply cable
2)
2.5 Ω
Cable between host and guest 1 Ω
1)
Limit the individual conductor resistance to the specified values to ensure that the light curtain functions
correctly. (Also observe IEC 60204-1.)
The specified values apply to the total resistance of each wire including contact and connector resis‐
tances.
2)
If a T distributor is used, the specified values apply to the resistance of the entire cable from the system
connec
tion of the device to the connection in the control cabinet.
For a cascade, the specified values apply to the resistance of the entire cable from the system connec‐
tion of the last guest device to the connection in the control cabinet.
Table 44: Technical data for receiver
Minimum Typical Maximum
Output signal switching devices
(OS
SDs)
2 PNP semiconductors, short-circuit protected
1)
, cross-
circuit monitored
Response time "Response time", page 131
Duration of OFF state 100 ms
Switch-on delay 3 × response
t
ime
ON state, switching voltage HIGH
(U
r
ms
)
2)
U
V
– 2.25 V 24 V U
V
OFF state, switching voltage LOW
2)
3)
0 V 0 V 2.0 V
Current-carrying capacity of the
O
SSDs
500 mA each
Leakage current of the OSSDs 2 mA each
Load capacity 2.2 µF
Load inductance 2.2 H
Test pulse data
4)
Test pulse width 150 µs 300 µs
Test pulse rate 3 s
-1
5 s
-1
10 s
-1
Discrepancy time (time offset
be
tween switching of OSSD2 and
OSSD1)
1 ms
Inputs
Input voltage HIGH (active)
2)
11 V 24 V 30 V
Input current HIGH 6 mA 10 mA 20 mA
Input voltage LOW (deactivated)
2)
–3 V 0 V 5 V
Input current LOW –2.5 mA 0 mA 0.5 mA
external device monitoring input (EDM)
Connected contactors
Permissible dropout time 300 ms
Permissible pull in time 300 ms
TECHNICAL DATA 13
8023872/18YZ/2021-01-14 | SICK O P E R A T I N G I N S T R U C T I O N S | deTec4 Ex II 3GD
129
Subject to change without notice

Table of Contents

Related product manuals