Symbology Reading Control
Operating Instructions
IDM corded & IDM Bluetooth
© SICK AG · Germany · All rights reserved · Subject to change without notice
3.7.26 DPM Code
If you own a DPM model (IDMxxx-x2xx) you can enable or disable the DPM code reading functionality by
scanning one of the following barcode commands.
Enable DPM functionality ◆
Disable DPM functionality
In order to verify if the DPM functionality is enabled, please scan the following barcode. If you can read this
barcode, the DPM functionality is enabled.
Test1
IDM Corded scanners: if you scan “factory default” and afterwards disconnect the scanner from your
host device, the DPM functionality will be disabled automatically.
IDM Bluetooth scanners: if you take out the battery the DPM functionality will be disabled
automatically.
If you disable the DPM functionality the performance of reading printed 1D and 2D codes will be
improved.
To Next Page
Loading...
Need help?
General