Operating Instructions
IDM corded & IDM Bluetooth
© SICK AG · Germany · All rights reserved · Subject to change without notice
3.9.6 Presentation Control, Scan Rate, Flash Duty
Option Code
Family Code
Selection
P.C. Parameter Selection
1D Corded
(IDM1x0)
2D Corded
(IDM2x0)
1D BT
(IDM1x1)
2D BT
(IDM2x1)
Presentation Control
SS Presentation mode 0 0 - -
SS Flash mode 1 - - -
SS Force mode 2 1 - -
Scan Rate Control
SS Dynamic 0 - 0 -
SS Fixed 1 - 1 -
Flash Duty Cycle
SS 1/2 duty cycle 0 - - -
SS 2/3 duty cycle 1 - - -
SS 3/4 duty cycle 2 - - -
SS 4/5 duty cycle 3 - - -
Presentation Control
When the scanner is placed on the Hands-free stand, the scanner will be switched from hand-held scanning to
hands-free scanning automatically. Three hands-free scanning modes are available. You are recommended to
use flash mode or force mode while under insufficient ambient light.
Scan Rate Control
The scanner will have better motion tolerance when you select “Fixed” scan rate. It’s suitable for applications
which need higher motion tolerance on the move. But this may impact to the reading distance.
Flash Duty Cycle
The Flash Duty Cycle is designed to control the flashing frequency of the light source.
To Next Page
Loading...
Need help?
General