9.5 Disassembling product
Approach
1. Switch off the supply voltage.
2. Mark the position and alignment of the product on the bracket or surroundings.
3. Disconnect and remove the connecting cables of the product.
4. Remove the product from the bracket.
Further topics
•
Putting the replacement product into operation
9.6 Putting the replacement product into operation
Approach
1. Mount and align the replacement product. When doing so, note the previously
applied markings on the bracket or surroundings.
2. Connect the connecting cables.
3. Switch on the supply voltage.
✓
The replacement product starts with its last permanently saved parameter set.
In the case of products that have not been used before, this corresponds to
the factory default setting. When a microSD memory card with parameter set
is inserted, the product automatically loads the compatible parameter set from
the external storage medium into the working memory and internal, permanent
parameter memory. The device then starts with its new valid parameter set.
4. Connect to the product via the configuration software.
5. Optional: transmit the parameter set of the product to be replaced by downloading
to the replacement product and permanently store this data there.
6. Flex product variant: readjust the focus position on the lens for the replacement
product. This is also required if the lens is not replaced.
TROUBLESHOOTING 9
8027859/1INN/2023-03-08 | SICK O P E R A T I N G I N S T R U C T I O N S | Lector85x
39
Subject to change without notice
To Next Page
Loading...
Need help?
General
