SICK Lector85x User Manual

2 Safety information
2.1 Intended use
The Lector85x image-based code reader is a SICK 4Dpro sensor. The product is used
for automatic, stationary identification and decoding of codes on moving or stationary
objects. The product reads 1D codes (barcodes, stacked codes) and 2D codes (matrix
codes). In read mode, the product transmits the read results via the host interface
(e.g. system controller) to a higher-level computer (e.g., PLC) for further centralized
processing.
Only the VI83I illumination units from SICK intended for integration in this application
can be used as an illumination unit.
The device is designed for use in industrial and logistics areas, and meets the require‐
ments for industrial ruggedness, interfaces and data processing.
Only use the device in industrial environments (EN 61000-6-4).
Incorrect use, improper modification, or tampering with the product will invalidate any
warranty offered by SICK AG. Furthermore, SICK AG shall not accept any responsibility
or liability for any resulting damage and consequential damage.
2.2 Improper use
Any use outside of the stated areas, in particular use outside of the technical specifica‐
tions and the requirements for intended use, will be deemed to be incorrect use.
•
The device does not constitute a safety component in accordance with the respec‐
tive applicable safety standards for machines.
•
The device must not be used in explosion-hazardous areas, in corrosive environ‐
ments or under extreme environmental conditions.
•
The device must not be operated in the temperature range below 0°C.
•
Any use of accessories not specifically approved by SICK AG is at your own risk.
WARNING
Danger due to improper use!
Any improper use can result in dangerous situations.
Therefore, observe the following information:
■
Product should be used only in accordance with its intended use.
■
All information in the documentation must be strictly observed.
■
Shut down the product immediately in case of damage.
2.3 Cybersecurity
Overview
To protect against cybersecurity threats, it is necessary to continuously monitor and
maintain a comprehensive cybersecurity concept. A suitable concept consists of organi‐
zational, technical, procedural, electronic, and physical levels of defense and considers
suitable measures for different types of risks. The measures implemented in this
product can only support protection against cybersecurity threats if the product is used
as part of such a concept.
You will find further information at www.sick.com/psirt, e.g.:
•
General information on cybersecurity
•
Contact option for reporting vulnerabilities
•
Information on known vulnerabilities (security advisories)
2 SAFETY INFORMATION
8
O P E R A T I N G I N S T R U C T I O N S | Lector85x 8027859/1INN/2023-03-08 | SICK
Subject to change without notice

SICK Lector85x Specifications

General

Brand	SICK
Model	Lector85x
Category	Measuring Instruments
Language	English