SICK TiM361S

8 Project planning
8.1 Manufacturer of the machine
WARNING
Risk of ineffectiveness of the protective device!
Persons and parts of the body to be protected may not recognized in case of non-obser‐
vance.
►
Use of the device requires a risk assessment. Check whether additional protective
measures are required.
►
Comply with the applicable national regulations derived from the application (e.g.,
work safety regulations, safety rules, or other relevant safety guidelines).
►
Apart from the procedures described in this document, the components of the
device must not be opened.
►
The device must not be tampered with or changed.
►
Improper repair of the device can lead to loss of the safety function. The protective
device must only be repaired by the manufacturer or by someone authorized by
the manufacturer.
8.2 Operating entity of the machine
WARNING
Risk of ineffectiveness of the protective device!
Persons and parts of the body to be protected may not recognized in case of non-obser‐
vance.
►
Changes to the electrical integration of the device in the machine controller and
changes to the mechanical mounting of the device necessitate a new risk assess‐
ment. The results of this risk assessment may require the entity operating the
machine to meet the obligations of a manufacturer.
►
Changes to the device’s configuration may impair the safety function of the device.
Therefore the device’s safety function and the effectiveness of the protective
device must be checked after any change in configuration. The person carrying out
the change is responsible for maintaining the safety function of the device and the
protective device.
►
The device must not be tampered with or changed.
►
Improper repair of the device can lead to loss of the safety function. The protective
device must only be repaired by the manufacturer or by someone authorized by
the manufacturer.
WARNING
Danger due to optical and electromagnetic ambient conditions!
Optical and electromagnetic ambient conditions can impair the functioning of the
device. This can result in loss of the safety functions.
•
Please note the following:
►
Avoid having strong electric fields in the vicinity of the device. These may be
caused by nearby welding or induction cables, for example.
►
Prevent condensation on and/or contamination of the optics cover. To ensure the
continuing, reliable safety function of the device, the optics cover must be cleaned
regularly.
PROJECT PLANNING
8
8022483/1LM2/2024-03-27 | SICK O P E R A T I N G I N S T R U C T I O N S | TiM361S
45
Subject to change without notice