2 Safety and Care
2 - 30 Instructions for Use
The following instructions describe cleaning the surface of the ultrasound system, including the
trackball and transducer holder.
To Do This
Clean and disinfect the
surface of the ultrasound
system
1. Power off the ultrasound system and unplug the power cord from the power outlet.
2. Use a clean gauze pad or lint-free cloth, lightly moistened with a mild detergent, to
wipe the surface of the ultrasound system.
If your system has a touch screen, take care to gently wipe the surface of the touch
screen.
Take particular care to clean the areas near the trackball and the slide controls.
Ensure these areas are free of coupling agent (gel) and any other visible residue.
Ensure that cleaning solution does not seep into the control panel, keyboard, or
any other openings.
3. After cleaning, use a clean, lint-free cloth to dry the surface.
4. As required, use an approved disinfectant wipe to disinfect the ultrasound system
and accessories.
5. Reconnect the ultrasound system power cord into the power outlet.
Clean and disinfect the
holders for transducers and
coupling gel
1. Remove the holder from the ultrasound system.
a. Reach under the holder to locate the tab on the holder. The tab extends below
the point of attachment to the ultrasound system.
b. Squeeze the tab towards the holder and pull the holder downward.
2. Clean the holder under running water, using a mild detergent and dry with a
lint-free cloth.
3. As required, use an approved disinfectant wipe to disinfect the holder.
4. Reattach the holder to the ultrasound system.
Align the support on the holder directly below the point of attachment on the
ultrasound system and firmly push upwards until the holder snaps into place.
To Next Page
Loading...
Need help?
General