Siemens Acuson S3000 - Using the Rear Brakes

3 System Setup
3 - 4 Instructions for Use
Task
Procedure
To set the front brakes:
 Press the center section of the front bumper down firmly with your foot until
the brakes lock into place. This is the lowest position for the front bumper.
To release the front brakes:
 Lift the center section of the front bumper from underneath until it clicks once,
using the top of your foot. This is the center position for the front bumper.
To set the swivel brakes:
 Lift the center section of the front bumper from underneath firmly until the
wheels are locked in a forward position, using the top of your foot. This is the
highest position for the front bumper.
To release the swivel brakes:
 Press the center section of the front bumper down with your foot until it clicks
once. This is the center position for the front bumper.
Using the Rear Brakes
The rear brakes are set individually as either unlocked or locked.
Rear Brakes.
Task Procedure
To set the rear brakes:  Using your foot, move lever to the Lock position until you hear a click.
To release the rear brakes:

Using your foot, move lever to the Unlock position until you hear a click.