Programming Manual of FC2005/FC901
4|63 A6V10333724_b_en_--
The dialer group is only used for sending information through DACT. Dialer group groups events of the zones
which assigned to it and report events as it self’s. This means if multiple children report the same kind of
events, dialer group will only report it once. Similarly, the restoral events should be sent only when all zones
in the group restore this kind of events.
There is one default dialer group:
· New Dialer Group 1. The system will assign the default zones and every new created zone to the
default dialer group.
To Next Page
Loading...
