M20 Terminal
Version 8 dated 15.03.00 206
Siemens Information and Communication Products
A
9.3 Operation requirements, CE conformity, restrictions of use
For operation requirements, see Chapter 3.5 “System requirements” on page 15, for CE conformity, see Chapter 3.6 “CE con-
formity” on page 15
.
For safety instructions, see Chapter
2 “Safety precautions for the user” on page 8.
9.4 Full-type approval
In reference to the approval requirements for M20 Terminal configurations, the following points must be observed:
1) No further approvals are required for application when using the M20 Terminal in approved configurations. Delta-
type approval is necessary if any accessories (handset, own MMI implementation supported by AT commands) other
than the approved accessories are used. Information about approved configurations and accessories that have been
approved for use with the M20 Terminal can be obtained in the appendix to EC TYPE EXAMINATION CERTIFI-
CATE or from your local distributor.
2) Applications using the "DATA ONLY" capabilities (data, SMS, fax) of the M20 Terminal need no further delta-type
approval.
To Next Page
Loading...
Need help?
General