Siemens M20 Terminal User Manual

AT command interface
Version 8 dated 15.03.00 29
Siemens Information and Communication Products
A
Table 5-1 Standard Hayes AT commands
*) Note
: it is not necessary to subsequently download a stored configuration (see commands AT&Y and AT&W) since
the stored configuration is automatically downloaded each time the system is started up.
5.3.1 Detailed description
AT%D Automatic dialling phone number in mem. "ME" index "1" with DTR Page 46
AT+DR V.42bis data compression reporting control Page 47
AT+DS V.42bis data compression control Page 48
AT+GCAP Request complete TA capabilities list Page 48
AT+GMI Request manufacturer identification Page 49
AT+GMM Request TA model identification Page 49
AT+GMR Request TA revision identification Page 49
AT+GOI Request global object identification Page 50
AT+GSN Request TA serial number identification Page 50
AT+ICF Set TE-TA control character framing Page 50
AT+IFC Set TE-TA local data flow control Page 51
AT+ILRR Set TE-TA local rate reporting mode Page 52
AT+IPR Set fixed local rate Page 53
A/ Repeat previous command line
Execute command
A/
Response
Repeat previous command line
Note:
it does not have to end with terminating character.
Parameter
Reference
V.25ter
Note
(pause)+++(pause) ESC from data mode to command mode
Execute command
+++(pause)
Response
If TA receives pause(0,5sec) +++ pause (0,5sec), TA interrupts the data flow on the AT interface,
switches to command mode.
Notice: The command is available only in data mode.
OK
Parameter
Reference
Hayes
Note
+++ is a Hayes command.
Command Function

Siemens M20 Terminal Specifications

General

Brand	Siemens
Model	M20 Terminal
Category	Engine
Language	English