AT command interface
Version 8 dated 15.03.00 30
Siemens Information and Communication Products
A
ATA Answer a call
Execute command
ATA
Response
TA causes remote station to go off- hook (i.e. answer call).
Note1
: any additional commands on the same command line are ignored.
Note2
: this command may be aborted generally by receiving a character during execution. This
command cannot be aborted in some connection setup states, such as handshaking.
If successfully connected
CONNECT<text> Note:
<text> only if parameter setting X>0
TA switches to data mode.
When TA returns to command mode after call release
OK
If no connection
NO CARRIER
Parameter
Reference
V.25ter
Note
ATD Mobile originated call to dial a number and call of supplementary services
To Next Page
Loading...
Need help?
General