AT command interface
Version 8 dated 15.03.00 52
Siemens Information and Communication Products
A
AT+ILRR Set TE-TA local rate reporting mode
Test command
AT+ILRR=?
Response
+ILRR: (list of supported <value>s) OK
Parameter
see set command
Read command
AT+ILRR?
Response
+ILRR: <value> OK
Parameter
see set command
Set command
AT+ILRR=
<value>
Response
This parameter setting determines whether or not an intermediate result code of local rate is repor-
ted at connection setup. The rate is applied after the final result code of the connection is transmitted
to TE.
OK
Parameter
<value> 0 Disables reporting of local port rate
1 Enables reporting of local port rate
Intermediate result
+ILLR:<rate>
Note:
It indicates port rate settings on connection.
Parameter
<rate> port rate setting on call connection in bauds per second
300
1200
2400
4800
9600
19200
28800
38400
57600
Reference
V.25ter
Note
To Next Page
Loading...
