Siemens M20 Terminal User Manual

Migration M1 to M20
Version 8 dated 15.03.00 210
Siemens Information and Communication Products
A
S06:002 F Not available
S07:060 S7=x
S08:002 F No effect at GSM
S09:006 Not available
S10:100 F S10=x
S12:050 F Not available
S14:2AH Set echo result code.... ATE,ATQ,ATV
S16:00H Function Internal use only
S18:002 Function Internal use only
S21:20H AT%Dn, AT&D,AT&C
S22:46H Reporting options ATXn
S23:16H Set local Bit rate and Parity +ipr=x,x
S25:005 Function Internal use only F
S26:001 Function Internal use only F
S27:00H Function Internal use only F
M1 Description M20
Class 5 : Enabled (%C1) Internal use only
Messages : On (Q0) Q0
/REL-Appendix : On (\V1) F +crc=x (0,1) reply is
V42B...
Requested service type : Stream (\L0) F Internal use only
Requested operating Mode : Normal (\N0) +cbst=x,0,(0 or 1)
BPS rate adjust : Off (\J0) F Internal use only
Echo : Off (\E0) F Echo E0
Terminal port flow control : RTS/CTS (\Q3) F Q0 no handshake
Q3 default HW handshake
+ifc=x,x
Modem port flow control : None (\G0) +ifc=x,x
XON/XOFF pass through : Disabled (\X0) F Internal use only
Auto-reliable buffering : None (\C0) F Internal use only
Fallback character : 0 (%A0) F Internal use only
Maximum block size : 256 (\A3) F Internal use only
Break type : Queued (\K5) F Internal use only
Inactivity timer : 0 (\T0) F Internal use only
Error summary In-Coming : 0 Out-going: 0 F Internal use only
Requested operating class : Class 2 (#C1) F Internal use only
Requested service level : Standard (#S1) F Internal use only
Maximum allowable errors : 2 (#E2) F Internal use only
Originator delay : 5 (#D5) F Internal use only
DCE speed : 9600 (#M6) F Internal use only
Parity generation : Disabled F Internal use only
Parity type : Even AT+ipr=x,x
Word length : 8 Bits At+ipr=x,x
Stop bits : 1 At+ipr=x,x

Siemens M20 Terminal Specifications

General

Brand	Siemens
Model	M20 Terminal
Category	Engine
Language	English