Siemens M20 Terminal User Manual

AT command interface
Version 8 dated 15.03.00 37
Siemens Information and Communication Products
A
ATDL Redial last telephone number used
Execute command
ATDL[;]
Response
TA attempts to set up an outgoing call to stored number.
Note:
this command may be aborted generally by receiving a character during execution. This com-
mand cannot be aborted in some connection setup states, such as handshaking.
If there is no last number or number is not valid:
+CME ERROR
or:
If no dialtone and (parameter setting X=2 or X=4)
NO DIALTONE
If busy and (parameter setting X=3 or X=4)
BUSY
If a connection cannot be set up
NO CARRIER
If successfully connected and non-voice call
CONNECT<text> Note:
<text> only if parameter setting X>0
TA switches to data state.
When TA returns to command mode after call release
OK
If successfully connected and voice call
OK
Parameter
<;> voice call
Reference
Siemens
Note

Siemens M20 Terminal Specifications

General

Brand	Siemens
Model	M20 Terminal
Category	Engine
Language	English