Siemens M20 Terminal User Manual

AT command interface
Version 8 dated 15.03.00 67
Siemens Information and Communication Products
A
AT+CLIP Calling line identification presentation
Test command
AT+CLIP=?
Response
+CLIP: (list of supported <n>s) OK
Parameter
see set command
Read command
AT+CLIP?
Response
+CLIP: <n>, <m> OK
If error is related to ME functionality:
+CME ERROR: <err>
Parameter
see set command
Set command
AT+CLIP=<n>
Response
TA enables or disables the presentation of the CLI at the TE. It has no effect on the execution of
the supplementary service CLIP in the network.
OK
Parameter
<n> 0 suppress unsolicited result codes
1 display unsolicited result codes
<m> 0 CLIP not provisioned
1 CLIP provisioned
2 unknown
Unsolicited result code
When CLIP is enabled at the TE (and is permitted by the calling subscriber), an unsolicited result
code is returned after every RING (or +CRING: <type>) at a mobile terminating call.
+CLIP: <number>, <type>
Note
: 4 different cases for +CLIP:
+CLIP: "number", <type>
+CLIP: "number pres restricted", <type>
+CLIP: "number not available", <type> (provider specific)
+CLIP: "", <type> (provider specific)
Parameter
<number> string type phone number of calling address in format specified by <type>
<type> type of address octet in integer format; 145 when dialling string includes internatio-
nal access code character "+", otherwise 129.
Reference
GSM 07.07
Note

Siemens M20 Terminal Specifications

General

Brand	Siemens
Model	M20 Terminal
Category	Engine
Language	English