Siemens M20 Terminal User Manual

AT command interface
Version 8 dated 15.03.00 89
Siemens Information and Communication Products
A
AT+FCLASS Fax: select, read or test service class
Test command
AT+FCLASS=?
Response
+FCLASS: (list of supported <n>s) OK
Parameter
see set command
Read command
AT+FCLASS?
Response
+FCLASS: <n> OK
Parameter
see set command
Set command
AT+FCLASS=
<n>
Response
TA sets a particular mode of operation (data, fax). This causes the TA to process information in a
manner suitable for that type of information.
OK
Parameter
<n> 0data
1 fax class 1 (TIA-578-A)
Reference
GSM 07.07
Note
Using ECM when faxing with GSM should be avoided. It can cause protocol conflicts at the pro-
vider side.
Additional Facsimile class 1 commands according to TIA/EIA-578-A can be used by FAX appli-
cations:
AT+FTS=<time> stop transmission and wait <time>*10ms intervals 0-255
AT+FRS=<time> wait for silence <time>*10ms intervals 0-255
AT+FTM=<mod> transmit data with <mod> carrier
AT+FRM=<mod> receive data with <mod> carrier
AT+FTH=<mod> transmit HDLC data with <mod> carrier
AT+FRH=<mod> receive HDLC data with <mod> carrier
AT+FMI Fax: report manufactured ID
Execute command
AT+FMI
Response
TA reports one or more lines of information text which permit the user to identify the manufactu-
rer.
<manufacturer Id> SIEMENS
Test command
AT+FMI=?
Response
OK
Parameter
Reference Note
AT+FMM Fax: report model ID
Test command
AT+FMM=?
Response
OK
Execute command
AT+FMM
Response
TA reports one or more lines of information text which permit the user to identify the specific mo-
del of device.
<model Id> M20
Parameters
<model Id> M20
Reference Note

Siemens M20 Terminal Specifications

General

Brand	Siemens
Model	M20 Terminal
Category	Engine
Language	English