40
SITRANS F M MAGFLO
DKFD.PS.027.W3.02
6. Installation of signal converter
Installation of signal conv.
1. Use a screw driver to remove the outer
frame.
2. Loosen the 4 screws retaining the control
pad.
3. Withdraw the control pad and turn it to the
required orientation.
4. Tighten the 4 screws until a mechanical
stop is felt in order to obtain IP 67 enclo-
sure rating.
5. Snap-lock the outer frame onto the control
pad (click).
The signal converter can be mounted in either
direction as the arrow indicates without turning
the terminal box.
The terminal box can be rotated ±90° in order
to optimize the viewing angle of the signal con-
verter display/keypad:
Unscrew the four screws in the bottom of the
terminal box. Turn the terminal box to the re-
quired position and retighten the screws firmly.
Turning the control pad
Turning the signal
converter
1
2
4
3
5
To Next Page
Loading...
