Siemens MAG 1100 - Remote Installation. Signal Converter in 19 Insert

44
SITRANS F M MAGFLO

DKFD.PS.027.W3.02
6. Installation of signal converter
Installation of signal conv.
6.2.4
Remote installation -
Signal converter in 19"
insert
1. Fit the SENSORPROM
®
memory unit on the connection board supplied with the signal
converter. The SENSORPROM
®
unit is supplied with the sensor in the terminal box.
2. Mount the guide rails into the rack system as shown. Distance between guide rails is 20 TE.
Guide rails are supplied with the rack system and not with the signal converter.
3. Mount the connection board as shown.
4. Connect the cables as shown under "Electrical connection", chapter 7.
5. Insert the signal converter into the rack system.