12 DKFD.PS.027.W3.02
2. Technical data
Technical data
SITRANS F M MAGFLO
Type Sensor with flanges
Design Straight Coned 1 DN reduction Straight
Nominal size
mm
25-40 50-300 350-1200
Liner Hard elastomer Composite elastomer Hard elastomer
(hard rubber) (hard & soft rubber) (hard rubber)
Liner approvals WRc WRc WRc
Medium temperature −5 to 90°C
Ambient temperature
Remote signal converter −40 to 90°C
Compact signal converter −20 to 50°C
Operating pressure 0.01 to 40 bar 0.03 to 20 bar 0.01 to 16 bar
Excitation frequency 12.5 Hz 50-65 mm: 12.5 Hz 3.125 Hz
80-150 mm: 6.25 Hz
200-300 mm: 3.125 Hz
Enclosure rating
Standard
IP 67 to EN 60529 1 m w.g. for 30 minutes
Option
IP 68 to EN 60529 10 m w.g. continuously
Cable entries 4 Pg 13.5
Mechanical load 18-1000 Hz random, 3.17 G rms in all directions to EN 60068-2-36
Test pressure 1.5 × nominal pressure
Flanges
EN 1092-1
Standard
PN 40 50-150 mm: PN 16 PN 10
200-300 mm: PN 10
Option
200-300 mm: PN 16 PN 16
ANSI B16.5
Standard
Class 150 lb Class 150 lb 14"-24": Class 150 lb
AWWA C-207 Standard 28"-48": Class D
Pressure drop at 3 m/sec. As straight pipe Max. 25 mbar As straight pipe
Electrodes AISI 316 Ti (1.4571)
PE/grounding electrodes
Standard
AISI 316 Ti (1.4571)
Measuring pipe/meter body AISI 304 (1.4301) Composite elastomer AISI 304 (1.4301)
Flanges Carbon steel
Housing Carbon steel
Surface finish Two component epoxy Polyester powder coat Two component epoxy
min. 150 microns min. 100 microns min. 150 microns
Colour RAL 7035 pale grey
Approvals
Conforms to
PED - 97/23EC, LVD - 73/23 EEC + amendment 93/68/EEC, EMC - 89/336 EEX1)
2.4 Sensor MAG 5100 W
1
) For sizes greater than 600 mm PED conformity is available as a cost added option, the basic unit will only carry the LVD (Low Voltage Directive)
and EMC approval.
MAG 5100 W
To Next Page
Loading...
