SITRANS F M MAGFLO
DKFD.PS.027.W3.02
6. Installation of signal converter
Installation of signal conv.
47
6.2.7
Installation in IP 65 panel
mounting enclosure
(front of panel)
1. Mount the SENSORPROM
®
memory unit on the connection board as shown.
The SENSORPROM
®
unit is supplied with the sensor in the terminal box.
2. Fit the enclosure in a cut out at the front of a panel. Fasten the four screws accessible at the
front.
3. Connect the cables as shown under "Electrical connection", chapter 7.
4. Insert the signal converter and close the cover.
To Next Page
Loading...
