International English 5 System Parameters
MICROMASTER 440 Operating instructions
6SE6400-5CA00-0BP0
59
Par. No. Parametername Default Acc WS QC
P1018 Fixed frequency mode - Bit 2 1 3 CT N
P1019 Fixed frequency mode - Bit 3 1 3 CT N
r1024 CO: Act. fixed frequency - 3 - -
P1025 Fixed frequency mode - Bit 4 1 3 CT N
P1027 Fixed frequency mode - Bit 5 1 3 CT N
P1031[3] Setpoint memory of the MOP 0 2 CUT N
P1032 Inhibit reverse direction of MOP 1 2 CT N
P1040[3] Setpoint of the MOP 5.00 2 CUT N
r1050 CO: Act. Output freq. of the MOP - 3 - -
P1058[3] JOG frequency right 5.00 2 CUT N
P1059[3] JOG frequency left 5.00 2 CUT N
P1060[3] JOG ramp-up time 10.00 2 CUT N
P1061[3] JOG ramp-down time 10.00 2 CUT N
P1070[3] CI: Main setpoint 755:0 3 CT N
P1071[3] CI: Main setpoint scaling 1:0 3 CT N
P1075[3] CI: Additional setpoint 0:0 3 CT N
P1076[3] CI: Additional setpoint scaling 1:0 3 CT N
r1078 CO: Total frequency setpoint - 3 - -
r1079 CO: Selected frequency setpoint - 3 - -
P1080[3] Min. frequency 0.00 1 CUT Q
P1082[3] Max. frequency 50.00 1 CT Q
P1091[3] Skip frequency 1 0.00 3 CUT N
P1092[3] Skip frequency 2 0.00 3 CUT N
P1093[3] Skip frequency 3 0.00 3 CUT N
P1094[3] Skip frequency 4 0.00 3 CUT N
P1101[3] Skip frequency bandwidth 2.00 3 CUT N
r1114 CO: Freq. setp. after dir. ctrl. - 3 - -
r1119 CO: Freq. setpoint before RFG - 3 - -
P1120[3] Ramp-up time 10.00 1 CUT Q
P1121[3] Ramp-down time 10.00 1 CUT Q
P1130[3] Ramp-up initial rounding time 0.00 2 CUT N
P1131[3] Ramp-up final rounding time 0.00 2 CUT N
P1132[3] Ramp-down initial rounding time 0.00 2 CUT N
P1133[3] Ramp-down final rounding time 0.00 2 CUT N
P1134[3] Rounding type 0 2 CUT N
P1135[3] OFF3 ramp-down time 5.00 2 CUT Q
r1170 CO: Frequency setpoint after RFG - 3 - -
http://nicontrols.com
To Next Page
Loading...
