5 System Parameters International English
MICROMASTER 440 Operating instructions
60 6SE6400-5CA00-0BP0
Drive Features (P0004 = 12)
Par. No. Parametername Default Acc WS QC
P0005[3] Display selection 21 2 CUT N
P0006 Display mode 2 3 CUT N
P0007 Backlight delay time 0 3 CUT N
P0011 Lock for user defined parameter 0 3 CUT N
P0012 Key for user defined parameter 0 3 CUT N
P0013[20] User defined parameter 0 3 CUT N
P1200 Flying start 0 2 CUT N
P1202[3] Motor-current: Flying start 100 3 CUT N
P1203[3] Search rate: Flying start 100 3 CUT N
r1205 Status flying-start on observer - 3 - -
P1210 Automatic restart 1 2 CUT N
P1211 Number of restart attempts 3 3 CUT N
P1215 Holding brake enable 0 2 T N
P1216 Holding brake release delay 1.0 2 T N
P1217 Holding time after ramp down 1.0 2 T N
P1232[3] DC braking current 100 2 CUT N
P1233[3] Duration of DC braking 0 2 CUT N
P1234[3] DC braking start frequency 0 2 CUT N
P1236[3] Compound braking current 0 2 CUT N
P1237 Dynamic braking 0 2 CUT N
P1240[3] Configuration of Vdc controller 1 3 CT N
r1242 CO: Switch-on level of Vdc-max - 3 - -
P1243[3] Dynamic factor of Vdc-max 100 3 CUT N
P1245[3] Switch on level kin. buffering 76 3 CUT N
P1247[3] Dyn. factor of kinetic buffering 100 3 CUT N
P1253[3] Vdc-controller output limitation 10 3 CUT N
P1254 Auto detect Vdc switch-on levels 1 3 CT N
P2354 PID tuning timeout length 240 3 CUT N
Motor Control (P0004 = 13)
Par. No. Parametername Default Acc WS QC
r0020 CO: Act. frequency setpoint - 3 - -
r0021 CO: Act. frequency - 2 - -
r0022 Act. rotor speed - 3 - -
r0024 CO: Act. output frequency - 3 - -
r0025 CO: Act. output voltage - 2 - -
r0027 CO: Act. output current - 2 - -
r0029 CO: Flux gen. current - 3 - -
r0030 CO: Torque gen. current - 3 - -
r0031 CO: Act. torque - 2 - -
r0032 CO: Act. power - 2 - -
r0038 CO: Act. power factor - 3 - -
r0056 CO/BO: Status of motor control - 3 - -
http://nicontrols.com
To Next Page
Loading...
