MicroSAM
Operating Instructions, 06/2012, C79000-G5376-C560-07
9
General information
2
2.1 Intended use
● This gas chromatograph is used to separate and quantitatively determine components in
a gaseous sample.
● The device may only be used for the purposes specified in these instructions.
● Modifications to the device which are not expressly referred to in these instructions
therefore result in an application which is not in accordance with the intended use. Such
modifications to the device are then the exclusive responsibility of the user.
2.2 Safety information
The gas chromatograph complies with the applicable safety standards. If the handling
instructions and safety information are observed, no dangers exist when using the device
which could endanger the health of personnel or result in damage to property.
You will find the safety information:
● In these operating instructions and in the manual
● On the gas chromatograph
● On the chromatograph components
WARNING
Only appropriately qualified persons are permitted to make interventions on this device.
These persons must be thoroughly familiar with all sources of danger and service
activities in accordance with these operating instructions.
For trouble-free and safe operation of this device, the following requirements must be
met:
Transportation in accordance with proper procedures
Proper storage
Proper installation and assembly
Careful operation and maintenance
To avoid injury to persons and damage to the device, please observe the information in
the manual.
To Next Page
Loading...
Need help?
General
