Service Bridge – Setup and Configuration
Entry ID: 109747975, V1.4, 05/2019
Siemens AG 2019 All rights reserved
4.2.2 "SELECT/SET" button
The "SELECT/SET" button function is configured in the "System > Button" menu.
The settings of the "SELECT / SET" button are adjusted to prevent incorrect
operation or incorrect configuration by unauthorized persons. The following settings
are provided for the Service Bridge:
System > Button
Figure 4-7
(1) The "Restore Factory Defaults" functionality is disabled, i.e. it is not possible to
reset to factory settings by means of the button during operation.
When the switch is powered up, the "Restore Factory Defaults"
functionality is always active, regardless of the configuration. This means
that in case of emergency, it is still possible to reset to factory settings
with the button during the power up after the system has been de-
energized.
To Next Page
Loading...
Need help?
General