Siemens SIMATIC 505 - Locations for Conditions Causing Profile Termination

Selected Functions
5-18
5.10 End-of-Profile Conditions
5.10.1
Different conditions cause profiles to terminate execution. Y ou can
determine the condition when the profile terminated by checking the
following:
• WX2
• (WY6)+
V12 for Clamp Close status bits
V13 for Inject status bits
V14 for Pack and Hold status bits
V15 for Plasticate status bits
V16 for Clamp Open status bits
T able 5-1 shows the types of conditions causing termination for the different
profiles.
T able 5-1 Locations for Conditions Causing Pr ofile T ermination
Profile Conditions Causing Termination of Profile
Max T ime Min Position Time Position Pressure Emergency
Clamp
Close
(WY6)+V12
(WY5)+V2 (WY5)+V15
to
(WY5)+V24
WY8 = 0
or
WY7
≠ 1 121
Inject
(WY6)+V13
(WY5)+V46 (WY5)+V59
to
(WY5)+V68
(WY5)+V47
and
(WY5)+V48
WY8 = 0
or
WY7
≠ 1 121
Pack/Hold
(WY6)+V14
(WY5)+V90 (WY5)+V103
to
(WY5)+V112
(WY5)+V91
and
(WY5)+V92
WY8 = 0
or
WY7
≠ 1 121
Plasticate
(WY6)+V15
(WY5)+V134 (WY5)+V147
to
(WY5)+V156
WY8 = 0
or
WY7
≠ 1 121
Clamp
Open
(WY6)+V16
(WY5)+V178 (WY5)+V191
to
(WY5)+V200
WY8 = 0
or
WY7
≠ 1 121
To disable
transition
conditions:
To disable transition
conditions, load
32767 in location
identified in
T able 2-9
T o disable transition
conditions, load
32767 in location
identified in
T able 2-9
Not Applicable Not Applicable
T o disable transition
conditions, load
32767 in location
identified in
T able 2-9
Not Applicable
Checking
End-of-Profile
Condition