Siemens SIMATIC 505 - 505 SoftShop Setup; Program Setup and Customization

Software Interface
2-31
T able 2-9 Upload T able Memory Map
Real-time Pr ocess V ariables, Cycle Status, SPC/SQC Data, Discr ete Status
Location Description Range
(WY6) 1* Actual loop calculation time 0—32767 microseconds
2 Clamp position feedback (CH9) 0—32000
3 Clamp velocity calculated by module

4 Clamp hydraulic flow output (CH1)

5 Clamp hydraulic pressure feedback (CH4)

6 Clamp pressure output signal (CH2)

7 Ram position feedback (CH7)

8 Ram velocity calculated by module

9 Ram hydraulic flow output (CH5)

10 Ram hydraulic pressure feedback (CH8)
↓
11 Ram hydraulic pressure output (CH6) 0—32000
12 Clamp close status bits 16 bits
13 Inject status bits

14 Pack and hold status bits

15 Plasticate status bits
↓
16 Clamp open status bits 16 bits
17 Inject final ram position 0—32000
18 Inject final calculated velocity

19 Inject final ram pressure
↓
20 Inject final cavity pressure 0—32000
21 Accumulated inject profile time 0—655.35 seconds
22 Pack and hold final ram position 0—32000
23 Pack and hold final calculated velocity

24 Pack and hold final ram pressure
↓
25 Pack and hold final cavity pressure 0—32000
26 Accumulated pack and hold profile time 0—655.35 seconds
27 Accumulated clamp close profile time

28 Accumulated plasticate profile time
↓
29 Accumulated clamp open profile time 0—655.35 seconds
* This value is updated only when profile is running. During other times the old value is left in place until
next profile.