Selected Functions
5-3
5.1.2
Each
profile can be programmed with as few as one or as many as ten steps.
W
ord WX1, module cycle status, is continuously updated with the profile
number and step number within that profile. See T
able 2-1 for WX1 details.
•
Step numbers, while the plasticate cycle is running by itself, are
reported as 401, 402, 403, etc., as in normal operation.
•
Step numbers, while the clamp opening cycle is running by itself, are
reported as 501, 502, 503, etc., as in normal operation.
•
While the plasticate and clamp open profiles are running
simultaneously (overlapping cycles), step numbers are reported in the
format
1xxyy
, where
1
indicates the overlapping operation,
xx
indicates
the plasticate step being run, and
yy
indicates the clamp open step
being run.
For example, WX1 = 10305 indicates overlapping operation with plasticate
profile in step 3 and clamp closing profile in step 5.
Step Numbers
To Next Page
Loading...
