Siemens SIMATIC 505 - Dipswitch SW1; Turboplastic Module Input;Output Configuration; Input;Output Configuration Switch Settings

Installation and Startup
3-5
3.2 Input/Output Configuration Switch Settings
T able 3-2 TurboPlastic Module Input/Output Configuration
Input/Output Configurations
Channel
Number
#1
SW1–1 = On
SW1–2 = On
#2
SW1–1 = Off
SW1–2 = On
#3
SW1–1 = On
SW1–2 = Off
1 Clamp flow Clamp/ram flow Camp flow
2 Clamp pressure Clamp/ram pressure Clamp pressure
3 Cavity pressure Cavity pressure Cavity pressure
4 Clamp hydraulic
pressure
Clamp hydraulic
pressure
Clamp hydraulic
pressure
5 Ram flow Not used Ram flow/pressure
6 Ram pressure Not used Not used
7 Ram position Ram position Ram position
8 Ram hydraulic pressure
Ram hydraulic pressure Ram hydraulic pressure
9 Clamp position Clamp position Clamp position
SW1 is the dipswitch located near the bottom edge of the module circuit board. See Figure 3-4 and Figure 3-5 .
Open=Off Closed=On
1 234
OPEN
Example:
1
and 2
are on
On = Depress end of rocker
switch at numbered side
Off = Depress end of rocker
switch at “open” side
Figure 3-4 Dipswitch SW1