Siemens SIMATIC 505 - V-Memory Block Write

Software Interface
2-30
2.7 Block Write Data: Module → PLC
The module performs a block write of 100 consecutive V -memory locations
starting at the V -memory location specified by WY6. See Figure 2-4.
T able 2-9 lists real-time variables and process values. The values in this
table are updated in V -memory every PLC scan.
Real-time process variables
(1 1 words)
Cycle status bits
(5 words)
End of cycle and
Cavity pressure data
(18 words)
SPC/SQC data
(21 words)
100
WY6
Discrete outputs status
(1 word)
Figure 2-4 V-Memory Block W rite