Siemens SIMATIC 505 - Additional Data Collected by Injection and Pack;Hold Profiles

Selected Functions
5-15
• Pressure Input Average. These 10 locations correspond to a profile
step data. (For example: if reporting data for a Clamp Close profile,
location 36 is the average pressure input for clamp close step 1 position
data.)
A veraging of each location is based on a 10-sliding-window value
method. For example, if the module took 20 pressure readings during a
step, the average pressure will be calculated (at the transition of the
step to the next) by using only the last 10 values. If the number of
pressure readings is less than 10, the module uses the actual number of
readings for calculating the average.
5.7.2
For Injection and Pack/Hold profiles, the module collects additional data at
the end of a profile:
• For Injection Profile:
V17 Inject final ram position
V18 Inject final calculated velocity
V19 Inject final ram pressure
V20 Inject final cavity pressure
• For Pack/Hold Profile:
V22 Pack/Hold final ram position
V23 Pack/Hold final calculated velocity
V24 Pack/Hold final ram pressure
V25 Pack/Hold final cavity pressure
Additional Data
Collected by
Injection and
Pack/Hold Pr ofiles